![]() If running a trace route is necessary, verify that there are not an excessive number of hops or significant response times. Conduct a practice test to verify that your testing site can successfully delivery an ACT WorkKeys test.Verify that workstations used for testing meet all additional requirements outlined in this document.Note: If possible, reduce the number of workstations able to use the shared bandwidth during test delivery. Others accessing the internet at your location to perform a large download at the time of testing.Network connectivity can be disrupted for various reasons including issues with your internet service provider (ISP).Examples (this list is abbreviated/not all inclusive): Factors outside of your control may have an impact on available bandwidth. From your data, determine a best estimate of the bandwidth expected to have available during ACT WorkKeys testing.See the section on “Throughput” under “Other Possible Concerns” for information on utilities available to test throughput speed. Verify the published throughput using the instructions in this document for throughput testing.Determine the number of workstations outside the lab that will be sharing your throughput at the same time as your examinees will be testing.Find out from your network administrator/engineer what the published bandwidth (throughput to the internet) is for your testing site.Verify that bandwidth meets minimum requirements.Confirm browser settings are correct on each workstation.Make sure that you ran the Validus validation test to verify that your systems meet all hardware and software requirements.Validation Test-this runs a demo test to validate that the workstation is compatible.TAO System Check-this checks your workstation for general capabilities and connectivity status.Use the Connect to TAO option in Validus to validate your workstations’ ability to use the test delivery system. Dial-up connections are not supported or allowed. Workstations must have broadband connections (256 Kbts/second or faster sustained download capacity to the workstation).The ACT domains (,, ,, , ) and address space cannot be blocked (e.g., through firewall, router, or other settings).Script ActiveX controls marked safe for scripting = Enable Firefox (no special setup required).Run ActiveX controls and plug-in = Enable.Internet Explorer 8, 9, and 10 Security settings (Tools > Internet Options > Security tab > Custom Level button) are required.The workstation browser must have JavaScript enabled and no AJAX (Asynchronous JavaScript and XML) blockers.Minimum size: 12 inches measured diagonally.Microsoft Internet Explorer 8, 9, 10, and 11 (enterprise mode).ACT WorkKeys tests may be delivered on desktop and laptop computers (iPads and other tablets are not allowed) that comply with the following specifications: desktop sharing applications, etc.) to access the ACT WorkKeys tests. Neither computers used by testing staff (Administrative Workstations) nor Test Delivery Workstations may use remote access technology (e.g. Examinees must not be allowed to remove any computer from the testing site. Technical Requirements and Troubleshooting ACT WorkKeys Online Technical SpecificationsĬomputers used by examinees to access ACT® WorkKeys® Online tests (Test Delivery Workstations) must always be under the control and supervision of the authorized location.
0 Comments
Leave a Reply. |